Begin by unplugging your appliance to⁢ ensure safety throughout the installation. Open ⁣the ⁢freezer compartment and carefully remove all shelves‌ and storage bins to create ⁤enough space to access the defrost heater.Depending‍ on your model, you may need to detach the back panel inside ⁣the⁢ freezer.Use a screwdriver to remove the screws holding the panel in place, then gently pull it away to expose the⁤ evaporator coils and ⁤the existing defrost heater. Keep track of the screws and any small ​parts for reassembly.

After locating the​ defrost heater, disconnect the wiring harness by​ pressing the release tab and pulling the connector apart.Remove the heater by sliding or unscrewing it from the mounting brackets-take note of its exact positioning for correct installation of your new OEM genuine Frigidaire defrost heater. When installing the new part, align it properly and secure it firmly​ before reconnecting the wiring.To verify ‍installation success, ‍follow this checklist:

  • Wires reconnected securely ⁣without any loose‍ ends
  • Back panel replaced and fastened with original screws
  • Appliance plugged in and tested for proper defrost cycle
Step Action Tip
1 Unplug appliance & remove freezer parts Keep screws in a small container
2 Remove back panel and disconnect‌ old heater Use ‍gentle force to avoid⁢ wire damage
3 Install new heater and reconnect wiring Double-check heater alignment
4 Replace panel, shelves, and power the unit Test for proper defrost operation